How Would Torklift GlowSteps Hand Rail Attach when Steps Attach to Tailgate

Question

Question:

How does the handrail work when the steps are mounted to the tailgate

asked by: John

0

Expert Reply:

When using the hand rail part # TLA7621 with a set of Torklift GlowSteps part # TLA7843 mounted to a tailgate you'd have to mount the middle rail of the hand rail to the top of the tailgate so that it matches up when the tailgate is folded down.

expert reply by: Jameson C

0

Answer 1

I reached out to my contact at Command and she said the LED RV Utility Light #328-K-0054B has a raw lumen output of 4,000, which makes for a really bright light for easy nighttime viewing. I have attached a short video review that you can check out…

view full answer...

Answer 2

I may have different installation method for you, but there is not an extended bracket made to push the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear #TLA7843 away from your camper to clear your bumper. It may be possible to have a…

view full answer...

Answer 3

Essentially it's how the two scissor steps store. The part #TLA7844 stores more like a traditional scissor step seen typically at the back of truck bed campers while the #TLA8004 stores more like what is seen on the side of campers. Since you…

view full answer...

Answer 4

While we do not have a video of these steps being specifically installed on your camper I took a look at the instruction manual, which is also linked, and there is a method for installing these steps on a camper that does not have a bumper. You would…

view full answer...

Answer 5

Thanks for reaching out, Jake! The front TorkLift Tie-Downs #TL34YR for your 2023 Ford Ranger uses 1/2" bolts that need to be torqued to 75 ft-lbs according to my contact at TorkLift.

view full answer...

Answer 6

The steps we carry that are the closest to your mounting hole measurements are the Flexco Manual Pull-Out Steps #SMFP-2120. The mounting holes are 20-1/2 by 7 inches. Unfortunately, there aren't any steps that we carry that are exactly the same…

view full answer...

Answer 7

The TorkLift GlowStep Stow N' Go part #TLA7843 are stored on the side of your camper attached with a bracket like in the photo I have attached. They do stick out on the side. You would need the GlowStep Revolution Scissor Step for it to store…

view full answer...

Answer 8

What I think you are asking is if the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear, #TLA7844 has a latching connection or some type of quick disconnect feature to remove from the camper. They do not have what I would call a quick…

view full answer...

How Would Torklift GlowSteps Hand Rail Attach when Steps Attach to Tailgate

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching