How to Use the Camco Gas Pressure Test Kit 10389

Question

Question:

Im looking at your Camco Gas Pressure Test Kit Item # CAM10389. The online video is helpful in describing the 3 different meter readings but, not on how it would be connected to a propane tank. I have a travel trailer that has to 20lb propane tanks. Do I disconnect each of the existing hoses from the tanks and attach the Camco hose? How is this done? Are there any videos you have that show this process? Thanks for your help!

asked by: Ken C

0

Expert Reply:

The Camco Gas Pressure Test Kit, # CAM10389 lets you test your gas system for leaks and system pressure at an appliance or at the gas controls. To test at the connection point of your supply tanks, remove supply hose from the regulator.

expert reply by: Michael R

0

Answer 1

The standard water column output for RV propane regulators is 11" like the MB Sturgis 2-Stage Propane Regulator part #108220 for vertical or part #108221 for horizontal which are what I recommend. That said, you can adjust them higher to…

view full answer...

Answer 2

You're not going to have any problems mixing Dexter and Lippert components on trailer axles over 10k-lbs in the same manner as below 10k-lbs as long as the measurements on the replacement parts are the same- i.e. bearing sizes are the same, etc..…

view full answer...

Answer 3

No, 12.5" water column is not too much for an RV propane system. Most propane regulators found on an RV system like the MB Sturgis Vertical 2-Stage Propane Regulator #108220 are going to have a water column of around 11". But, the pressure…

view full answer...

Answer 4

Many times Dexter hubs will fit on a Lippert axle, but Lippert does have a few axles out there with special spindle sizes. Every Lippert axle comes with a tag or plate on the axle that gives a serial number or NV number. If you can give me that…

view full answer...

Answer 5

Yes we do offer the replacement gasket for the #F02-3106BK with the part #F02-3104VP.

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 8

Hello Gaby. I reached out to the manufacturer and found out that the UltraFab Weld-On Jumbo Steel Roller #UF48-979023 uses a 6-1.0mm Zerk fitting. For a replacement you can use the following: - Replacement Brass Grease Zerk for Weld-On Hinges - 6 mm…

view full answer...

How to Use the Camco Gas Pressure Test Kit 10389

Product Page this Question was Asked From

Continue Researching