What is the Weight of the Roadmaster High-Low Adapter # RO24FR?

Question

Question:

This adapter is the perfect 6-inch rise that I need for my 2-inch hitch on my 2022 Toyota Sienna. How much does the adapter weigh in total?

asked by: Lisa

0

Expert Reply:

The Roadmaster High-Low Adapter for Tow Bar - 2.5" Hitch - 6" Rise/Drop # RO24FR weighs a total of 14 pounds.
It is important to note that any time you use a hitch adapter, you decrease the overall weight capacity of the hitch by 50%.

expert reply by: Bob C

0

Answer 1

Based on your dimensions you'd need 7 inches for your tow bar to be totally level. So since there's only a 6 inch and an 8 inch high low adapter the better choice is to have the sitting slightly higher on the RV side. If a tow bar pulling…

view full answer...

Answer 2

You can use a Hi-Low Hitch to level the RV hitch to the tow bar. These hitches have a solid-steel shank, allowing a 10,000-pound capacity and 400-pound tongue weight. I do not have a dimensional drawing at this time but I did go out to our warehouse…

view full answer...

Answer 3

Having your tow bar as level as possible is the best way to have it set up. Because of that you would want the 6 inch drop adapter. I have spoken to tow bar manufacturers and they say one of the key factors in how long a tow bar will last is how…

view full answer...

Answer 4

Any type of hitch adapter or extender will have the unavoidable side-effect of causing a loss of about half of your hitch's rated capacity, both its tongue weight (TW) and it's gross towing weight (GTW). Hidden Hitch extender #HE18 and Curt…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 10

Hi Robert; hopefully your Roadmaster tow bar is one that attaches to direct-connect base plates as opposed to crossbar base plates; for example the 8,000 lb Roadmaster Sterling would be optimal. Assuming that, here is what you need to flat tow your…

view full answer...

What is the Weight of the Roadmaster High-Low Adapter # RO24FR?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching