How Many Charging Amps Does The Hopkins Engager Break Away Kit Draw When Charging The Battery?

Question

Question:

How many amps does the charger charge at?

asked by: Brian

0

Expert Reply:

I spoke with Hopkins and their Engager Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger # 20400 has a 2 amp charger. This will include a battery that has a 5 amp-hour capacity and has a built-in shut-off feature that activates when the battery is fully charged.

expert reply by: Lazer S

0

Answer 1

On this page (typically below the product links) there is a helpful link section that will have the install instructions fo the Hopkins Breakaway kit part #20400 that you referenced. I also attached an install video that shows the kit installed as…

view full answer...

Answer 2

You can absolutely install E-Tracks like the etrailer Horizontal E-Track - Black Powder Coated Steel - 2,000 lbs - 94" Long - Qty 4 #e42VR you were looking at in your Forest River Enclosed Cargo Trailer yourself. Now there are a few things to…

view full answer...

Answer 3

You will want to use a marine battery in addition to the Hopkins Engager #20400 because you want a dedicated battery for your breakaway brake function. If your marine battery was depleted and the pin pulled for the breakaway system then this means…

view full answer...

Answer 4

The Hopkins Engager Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger part #20400 has a maximum power amp draw of 2 amps to charge the breakaway battery. The power draw is so low is will not drain the tow vehicle's battery. It will…

view full answer...

Answer 5

You need an electric breakaway when you have electric brakes on your trailer. A breakaway system is required by law in most states for trailers that are equipped with electric brakes and have a GTW of at least 3,000 lbs. Hopkins Engager Breakaway Kit…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 12

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...