Product Weight Of Buyers Products 8 Inch Wheel Chocks With 3 Foot Rope

Question

Question:

What is the weight for the set of two chicks with the attached rope? Need to keep things light so as not to exceed the OCCC for our unit.

asked by: Jerry G

0

Expert Reply:

The Buyers Products 8" Wheel Chocks With 3' Rope # 337WC24483 weighs 6-lbs.

expert reply by: Bryce D

0

Answer 1

All-around the Stromberg Carlson Electric Trailer Jack #JET-5000NG is nicer than the #JET-5000. The bearings in the part #JET-5000NG allow it to raise and lower much smoother and quicker, the size of the head is a bit smaller and the lighting is…

view full answer...

Answer 2

To activate the brakes on a trailer with your 2024 Toyota Grand Highlander you'll need a 7-way connector and brake controller. To switch over from your 4-pin connector you can install the #ETBC7L. This will plug into your 4-pole connector…

view full answer...

Answer 3

The #UF48-979002 feature oversized footplates that are 4-1/2" wide by 9" long, so you could use them without leveling blocks. However, it's not uncommon for people to use leveling blocks like #A10-0918 or even wooden blocks under these…

view full answer...

Answer 4

The 15,000 Btu Furrion Chill HE AC like the part #FR23PV does indeed have a start capacitor. In regard to the starting power needed, I reached out to Furrion, who told me the 15,000 Btu Chill AC's require 30 amps and 2,500 starting watts. So that…

view full answer...

Answer 5

In order to keep a trailer from rolling on a slight incline, what you will need are wheel chocks. You will simply put them behind your trailer tires and that will prevent the trailer from rolling away from you. You'll want to get wheel chocks…

view full answer...

Answer 6

The weight distribution system that has the best sway control and is properly rated for your tongue weight that will be between 450 and 500 lbs is the Reese Strait Line part #RP66083. This would be my first pick as your best option as it has a tongue…

view full answer...

Answer 7

The InfiniteRule Lock for Demco eZ-Latch #IR66FR will fit 2" and 2-5/16" couplers. This lock has an internal length of 2-15/16" to fit the pin hole on your coupler. I have linked an image below showing it on a 2-5/16" coupler in…

view full answer...

Answer 8

I attached a picture that shows what type of lighting requirements are needed for a trailer over 80 inches in width as well as a link down below that covers this as well.

view full answer...

Answer 9

Yes, if you check out the picture I attached you can see the GearSpace Carrier part #HGK826 installed in the hitch of a Roadtrek RV built on a Mercedes Sprinter chassis and the door was able to open with the carrier slid out.

view full answer...