Recommended Ramp For Loading Mower on 48 Inch Tall Flat Bed Truck

Question

Question:

Hello, I am looking for ramps that will load a mower into a 48 loading height flat bed truck. What suggestions might you have? Thank you

asked by: Scott

0

Expert Reply:

Based on the height of your truck you will more than likely need a 12' ramp like the # GH54FR. You will need to make sure you not only have a safe angle for the ramp to load the mower but also enough clearance based on the angle where the ramp meets the truck bed. You will have to determine what is necessary based on the clearance of the mower you plan to load.

expert reply by: Robin H

0

Answer 1

The Gen-Y Hitch Aluminum Loading Ramp Set - 96" Long x 15" Wide #325-GH-R96 have a combined weight capacity of 10,000 lbs. As long as your Crown C-5 forklift does not exceed this weight capacity they will be able to handle the 10K weight.…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Recommended Ramp For Loading Mower on 48 Inch Tall Flat Bed Truck

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching