How To Locate Installers For SumoSprings Solor Custom Helper Springs # SSR-307-47

Question

Question:

Hi, are there any recommended installers/dealers in my area for suspension enhancements coils, airbags, struts, etc. in my area: San Antonio, 78245. thx

asked by: James K

1

Helpful Expert Reply:

You can find an installer in your area for your SumoSprings Solo Custom Helper Springs - Rear Axle # SSR-307-47 using the "Locate Installers Near Me" link located just under the videos on the product page.

expert reply by: Kevin C

1

Installer Locater
(click to enlarge)

Answer 1

I recommend the Timbren #TDR1500DS for your 2016 Ram 1500. They're for standard occasional towing with a capacity of 6,000 pounds. They're confirmed on your Ram as long as you don't have a factory air suspension system. The 6,000 pound…

view full answer...

Answer 2

If your 2013 Dodge Ram 1500 is a crew or quad cab then you can use the Timbren springs #TDR1500DQ. The coil springs at the back are not an issue. I have included a link to a video showing a typical installation of this system. As you can see the…

view full answer...

Answer 3

Using a Timbren system like #TDR1500DQ would be my exact recommendation for this application. The Timbren system is going to do exactly what you need it to. It will take out that squat you are getting. It will also help with body roll and stability…

view full answer...

Answer 4

Your camper that weighs 6,000 lbs is going to have a tongue weight figure of 600-900 lbs so based on that I would go with a lighter duty Timbren part #TDR1500DS which has the 6,000 lb rating. The problem with the higher capacity Timbrens is that they…

view full answer...

Answer 5

I went out to our warehouse to take a look at the Timbren Rear Suspension Enhancement System #TDR1500DS and measured an overall height on the springs of right at 6-1/4 inches. I have attached an image to assist. These particular springs are designed…

view full answer...

Answer 6

I will be happy to provide some dimensions for you for the Timbren rear suspension enhancement system, #TDR1500DQ, for your 2012 Ram 1500. First, the height of the spring by itself is 5-1/2 inches. The springs have a diameter of 4 inches. I have…

view full answer...

Answer 7

As long as you aren't exceeding the towing capacity of your truck the Timbren rear suspension kit part #TDR1500DQ that you referenced would not have any problems towing a 14,000 lb trailer.

view full answer...

Answer 8

The Timbren Vehicle Suspension, #TDR1500DQ, actually snap into place just like the old bump stops. They are pressed into the cup like you see in the video, linked for reference. I have also included a link to the instructions. The video uses a 2009…

view full answer...

Answer 9

I'd first try adding more spring bar tension from your weight distribution system as it sounds like you may not have it setup properly as it's a properly rated system and you are still experiencing sag. That said the Timbren kit I would…

view full answer...

Answer 10

For your 2020 Ram 1500 and how you plan to use your truck the best suspension enhancement is the SumoSprings Solo part #SSR-307-40. This kit is the better balance between ride quality and support than the Timbren you mentioned as well. Timbrens are…

view full answer...

Answer 11

We offer two SumoSprings options for your Ram 1500 Classic. For 1000 lbs of support, use the #SSR-307-40 kit you'd looked at. For up to 1500 lbs of support, use #SSR-307-47. Either kit is compatible with in-bed 5th wheel or gooseneck hitches. If…

view full answer...

Answer 12

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

How To Locate Installers For SumoSprings Solor Custom Helper Springs # SSR-307-47

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching