Weight Distribution for Trailer Tongue Weight of 1,000 lbs

Question

Question:

Have a 2021 ram 1500 4x4 bighorn pulling a Kodak 283bhsl have been using older Reese hitch am wanting to get newer rated for about 1000 tongue wt

asked by: Mike

0

Expert Reply:

Since your tongue weight is right at 1,000 lbs the Reese Trunnion system part # RP66542 would be a great option with a tongue weight range of 600-1,200 lbs.

expert reply by: Jameson C

0

Answer 1

If your trailer weighs more than 50 percent of the total weight of your tow vehicle we recommend the use of a weight distribution system. The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup…

view full answer...

Answer 2

I looked up the towing capacity of your 2019 Ram 1500 and based on it's very impressive capacities it would easily be able to tow a trailer that weighs 6,100 lbs. A weight distribution system like the part #RP66542 that you referenced…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 6

Hi Joe, Yep, you heard correct, you can go from a 2 inch shank to a 2-1/2 inch shank with your Reese weight distribution hitch without issue. One of the following 2-1/2 inch shanks should have the right rise/drop for your application. Here are the…

view full answer...

Answer 7

Weight distribution works to distribute the tongue weight of a trailer up to the front axle of the tow vehicle so that it will sit more level and handle/brake better. That being said the systems do not "reduce" tongue weight or allow you to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey Dennis, we have a replacement 7-way plug with the part #A7WCB which would work great to replace your damaged one. I attached a diagram for 7-ways for you to check out as well.

view full answer...

Answer 10

The round or trunnion bars refers to the end of the spring bars. Round bars are typically designed for lighter applications, are a bit harder to install and are usually priced lower than trunnion bars. Trunnion bars are typically designed to be used…

view full answer...

Weight Distribution for Trailer Tongue Weight of 1,000 lbs

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching