Can Yakima OnRamp Bike Rack Carry E-Bike and Road Bike

Question

Question:

I need to carry an electric bike and a road bike. Will this rack accommodate a road bike?

asked by: Doug

1

Helpful Expert Reply:

Yes, the Yakima OnRamp bike rack part # Y96FR can carry a road bike as well as an e-bike. I attached a review video for this rack for you to check out as well.

expert reply by: Jameson C

1

Answer 1

I do have an option for you but the highest rated bike rack we offer for a 1-1/4" trailer hitch is 66 lbs, with the Yakima OnRamp Bike Rack for 2 Electric Bikes part #Y96FR. That said, you should be able to remove the battery from the bike and…

view full answer...

Answer 2

The Hollywood Racks Road Runner 4 Bike Carrier part #HR400 will work just fine with any swing-away adapter. I really couldn't say one works better than another so I recommend going the most cost effective route which is the Yakima BackSwing Swing…

view full answer...

Answer 3

Yes the Yakima OnRamp part #Y36FR does tilt down to help with rear cargo area access like you can see in the attached picture you mentioned. The only functional difference between this rack and the #Y96FR is the hitch it is designed to fit like you…

view full answer...

Answer 4

The Hollywood Racks RV Rider part #HLY64FR would be perfect for what you are looking for. It has an 80 lb per bike weight capacity, has wheel hoops wide enough for 5 inch wide tires, and is approved for use at the rear of a fifth wheel trailer like…

view full answer...

Answer 5

Yes, with the Kuat Pivoting assembly part #PVD20B swung out all the way you would be able to fully swing open the rear door of your Sprinter. We had a customer with a similar Sprinter send us a picture where you can see that it would give the…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

To add a class III hitch to your 2024 Honda CR-V hybrid, I recommend the Curt Trailer Hitch item #C13397. This hitch is custom fit and bolts to your CR-V with included hardware. It is a class III hitch with a 2" receiver. I really like this…

view full answer...

Answer 12

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Can Yakima OnRamp Bike Rack Carry E-Bike and Road Bike

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching