Curt Ball and Safety Chain Kit For Ford F-250 Super Duty OEM Puck System

Question

Question:

Will Curtis gooseneck ball and safety chain anchors model 60618 fit a F-250 with puck system in bed

asked by: Chris

1

Helpful Expert Reply:

We do have the Curt gooseneck ball and safety chain kit that fits your Ford F-250 with the OEM puck system in the bed, though it's a different part number than the one you mentioned, which is for Ram trucks. Instead, the correct part for your Ford is the following:

- Curt Ball and Safety Chain Loop Kit # C38CR

The Curt # C38CR is a really nice choice for your Ford as the hitch ball is simple to use with its integrated lever in the head that you just have to lift to install or remove the hitch ball from the bed. It even has a rubber hole cover and carrying case for the ball that you can use when you want to take the hitch ball out and have a clean truck bed.

expert reply by: Kyle S

1

Answer 1

The OEM location for the gooseneck ball hole in the bed of your 2020 Ford F-350 will be 45-1/2 inches forward from the rear edge of the truck bed. There would be a flat spot in the bed where the ball will install as well. I attached a picture that…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 3

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 4

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack…

view full answer...

Answer 5

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 8

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 9

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 10

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 11

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Curt Ball and Safety Chain Kit For Ford F-250 Super Duty OEM Puck System

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching