Replacement 12 Volt On Off Rocker Switch

Question

Question:

Do you have 12 volt on off rocker switches? If so where would I find them?

asked by: Bob A

0

Expert Reply:

Yes we do have them. I personally prefer the Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 3-Blade - Red Pilot Light # PK34360. The red indicator light lets you know if it is on or off from a distance.

If you like the simple standard look we have the Single Rocker Switch - Labeled On/Off - SPST - Black # 37212595. It doesn't have a light indicator it is just labeled with ON/OFF.

We also have the Single Rocker Switch - 12V - On/Off - SPST - Black Plate with Blue Illuminated Switch # 37213685. If you like the switches that light up its a good choice too. This one will illuminate blue.

expert reply by: David B

0

Answer 1

The IP66/206 Single RV Switch Faceplate - Black #37214045 has inside dimensions of 7/8 inch by 1-1/2 inches. I have attached some photos to assist. I can't find the JR 19-872 you referenced to compare fit.

view full answer...

Answer 2

Yes you could use the faceplate switch part #37212855 with the RV Switch part #37213055 that you referenced.

view full answer...

Answer 3

When we measured the cut out dimensions, we found that they were 1-1/8" tall x 9/16" wide, so that is the actual dimension for the JR Products Illuminated 12V On/Off Single Rocker Switch. This switch comes in three different colors…

view full answer...

Answer 4

It does, yes, the RV switch does have the exact dimensions needed to fit in the cut out of the double rocker switch. So the two parts are indeed compatible: - RV Switch - On/On - DPDT - Black #37213055 - Double Rocker Switch - On/Off - Black…

view full answer...

Answer 5

Yes! The RV Switch - On/On - SPDT #37213095 can be used to replace the switches from the Double Rocker Switch - On/Off #37212235 that you mention.

view full answer...

Answer 6

A 2-way switch is the same as an SPDT switch. SPDT switches use three terminals and it stands for single pole, double throw. To answer your question, the #37213095 RV Switch - On/On is an SPDT switch, so it may be used for a 2-way switch. I have…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 12

Yes, it will! The Reese 5th Wheel Rail Adapter item #RP30154 is compatible with an Anderson 5th wheel hitch that attaches to industry standard rails. This adapter will drop right down into the pucks of the Ram factory prep package. Please note that…

view full answer...

Replacement 12 Volt On Off Rocker Switch

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching