Replacement Handle And Crank For A Ventline RV Vent

Question

Question:

Trying to find a handle assembly for this ventline vent.

asked by: Heber

0

Expert Reply:

If your Ventline Vent has a crank handle then you'll want the Replacement Operator, Knob and Screw for Ventline Ventadome Trailer Roof Vents w/ Wedge-Shaped Dome # BVD0462-00. If you have the T-Handle design that slides then you'll want the Replacement Handle Assembly for Ventline E-Z Lift Ventadome Trailer Roof Vents # BVC0580-00.

expert reply by: Kevin C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey David, thanks for the picture. I was able to track down a spec sheet for your Dexter axle which I have included below. The 031-029-02 bearing is item #15123 and the 031-030-02 bearing is item #25580. For a bearing kit you can use part #BK3-110…

view full answer...

Answer 5

Hi Kat, The rubber bumpers that we offer are all 96" in length but can come in different widths. Based on the dimensions you provided i your pictures the #D3-96 is going to be the best fit, but you will have to cut it down to size.

view full answer...

Answer 6

Yes, the Replacement Cover #PE48UV will indeed fit the 2018 Ford F-150 extended cab with the 67" bed. This is made to be a replacement cover for the Pace Edwards JackRabbit Retractable Hard Tonneau Cover #311-JRFA05A28 which is specifically for…

view full answer...

Answer 7

Hey Al, this is a great question but since you have free-backing plates now you would never need to mess with the manual lock out of your Atwood coupler.

view full answer...

Answer 8

Hello Rosemary. For a replacement shroud for your Coleman TSR 7300 Series rooftop AC you can use the MaxxAir TuffMaxx Replacement RV Air Conditioner Cover #MA00-325001. The TSR 7300 series is also known as the Mach 3 which does fall under the fit for…

view full answer...

Answer 9

To replace the controller for the Replacement Vacuum Generator for Dometic VacuFlush RV Toilet #DOM46FR you need the Replacement Touchpad for Dometic VacuFlush and MasterFlush RV Toilets #DOM36FR.

view full answer...

Answer 10

The bumper part #D3-96 that you referenced is our best option and could work for you but you will need to make some modifications. You would need to cut it down to the 84 inch length you need and would also need to drill new holes in it that line up…

view full answer...

Replacement Handle And Crank For A Ventline RV Vent

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching