Heat Strip Recommendation for Furrion 14.5k Chill Roof Top AC Unit

Question

Question:

The item is listed with the item number of FR35SR. Is that the same thing as C-FACR15SA-A02, this number is listed as an alt item in the description. Furrion said that my installed unit requires C-FACR15SA-A02 so I wanted to make sure that this is the right part before ordering. I have the wall thermostat control Furrion Chill 14.5 unit installed. It is a 2022 Grand Design 265BH travel trailer.

asked by: Jimmy H

0

Expert Reply:

Yes the Furrion Heat Strip Add-On for Furrion Air Conditioner # FR35SR is the correct heat strip for your Furrion Chill 14.5k BTU unit.

expert reply by: Jameson C

0

Answer 1

The heat strip like the #FR35SR basically has the same setting as the fan of the AC unit it installs it. It's just a heating element that your blower will blow air past so whatever blower volume setting your AC has this would work with.

view full answer...

Answer 2

Yes the Furrion heat strip part #FR35SR does fit the ducted Furrion 14.5k BTU AC units like you mentioned having.

view full answer...

Answer 3

Furrion does have a heat strip available for their Chill RV AC Units with the part #FR35SR. Here is the instructions for installing this on a Chill unit: You will need to remove the 10 screws holding the top cover on, remove the EPP top cover of the…

view full answer...

Answer 4

For your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817 or #LC358590 you need to reset the leveling memory. The “Zero Point” is the programmed point that the trailer will return to each time the Auto Level feature is used…

view full answer...

Answer 5

Choosing the correct brake assemblies will depend on the weight capacity of your trailer's axle and the size of the brakes. A 2,000 pound axle will use 7 inch brakes like #AKEBRK-2. A 3,500 pound axle will use 10 inch brakes like #AKEBRK-35-SA.…

view full answer...

Answer 6

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 7

When installing the #FACC12SA-BL the two brown wires do not have a pre-determined positive/negative so you can connect either one to either of the furnace wires and it will function properly. If you're going to run the furnace you will need to…

view full answer...

Answer 8

I attached a picture I got from Furrion that shows a wiring diagram for the #FACC12SA-BL as well as an install video for you to check out.

view full answer...

Answer 9

The Furrion Heat Strip Add-On for Furrion Air Conditioner #FR35SR is only compatible with Furrion AC units that have a manual air distribution box like the Replacement Air Distribution Box w/ Built-in Thermostat for Furrion Chill RV Air Conditioner -…

view full answer...

Answer 10

The Torklift Hitch Extension part #TLE1636 that you referenced can tow a trailer that weighs 6,700 lbs like you what you have but you would need to use a weight distribution system with it to have the needed capacity as without a WD system it's…

view full answer...

Answer 11

Hi Robert; hopefully your Roadmaster tow bar is one that attaches to direct-connect base plates as opposed to crossbar base plates; for example the 8,000 lb Roadmaster Sterling would be optimal. Assuming that, here is what you need to flat tow your…

view full answer...

Answer 12

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Heat Strip Recommendation for Furrion 14.5k Chill Roof Top AC Unit

Product Page this Question was Asked From

Continue Researching