Troubleshooting An A-Frame Trailer Jack Motor That Will Not Function
Question:
Jack will raise manually but when switch activated motor runs but jack does not raise or lower
asked by: Billbowden
Expert Reply:
Since your jack is still working manually the issue is not with your gears but with the motor itself. Unfortunately this is a common issue with jacks and there aren't replacement motors available from most manufacturers so you would need to just completely replace the jack. Before replacing the jack I do recommend checking any in-line fuses and the wiring with a voltage tester like the # PTW2992 to ensure the issue isn't simply a lack of current running to the motor.
For a jack with a 3,500lb weight capacity and 18" lift I recommend the Lippert Electric Trailer Jack with Footplate # LC285318. This jack has a bolt-on design and can extend 6" in 41 seconds. It has 2 toggle switches on the front of the housing let you operate the jack. An on/off switch controls the light to make coupling/uncoupling your trailer in the dark easy peasy and an extend/retract switch that controls up and down movement. It has a black powder coat finish that resists rust and corrosion for an extended lifespan.
I've attached a review video for you as well that will offer some additional information as well as show you this jack inaction.
Products Referenced in This Question
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Q&A: Hitch Extender For 2-1/2 Inch Hitch For Weight Distribution
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Replacement For A-Frame Tongue Jack on Lippert Electric Ground Control TT
- Article: RV Pre-Departure Checklist
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Article: Trailer Wiring Diagrams
- Q&A: Correct Replacement for an Atwood Water Heater GC6AA-9E
- Article: Trailer Jacks
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Most Popular Wheel Bearings
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Trailer Hitch Drop