Wiring For Third Brake Light on Trailer

Question

Question:

I have a small trailer from harbor freight that I pull behind my gold wing I have a flat 4 pin connector off bike I want to run a high up 3rd brake light plus my normal 2 lights on trailer do you have a wiring harness that will do all of that

asked by: James W

0

Expert Reply:

You can add in a third brake light on your trailer without having to get a new wiring harness or anything like that. All you'll need is a module:

- 3rd Brake Light Logic Module # PP20-702

The # PP20-702 is pretty simple; you'll connect the third brake light to it and the module simply takes the signal from the tail lights and filters out the turn signals.

expert reply by: Kyle S

0

Answer 1

We have the exact part you need for a third brake light that will filter out the turn signals, the 3rd Brake Light Logic Module #PP20-702. This is simple to use as well, and I have added a cut out of the instructions for you.

view full answer...

Answer 2

Yes, you can use the factory trailer connector on your 2015 Nissan Titan to power the third brake light on your Leer camper shell. That said, they don't make a plug and play harness for this so you will need to do some wiring but no splicing…

view full answer...

Answer 3

You can use 7-way trailer wiring with the module part #PP20-702 to provide power to the third brake light of your camper shell/cap. Basically the stop/turn circuits of the trailer wiring need to run to the yellow wires of this module and then the…

view full answer...

Answer 4

There is a simple solution to get the isolated brake signal from your combined turn signal and brake wiring. You will simply use the Pacer Performance 3rd Brake Light Logic Module #PP20-702. The module filters out the unwanted turn signal. This will…

view full answer...

Answer 5

In order to successfully wire in a third brake light on a camper shell you need to identify first if the taillights on the vehicle are combined or separate meaning, are the stop and turn signals on the same circuit or separate. If they're…

view full answer...

Answer 6

The logic box that you are asking about is our Pacer Performance 3rd Brake Light Logic Module #PP20-702. This is a piece of equipment that is required when using an LED light as a 3rd brake light. If there is a specific light style that you are…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Wiring For Third Brake Light on Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching