Will 13,500 Btu Furrion Chill AC Run on 15 Amp Circuit

Question

Question:

Will the 13.5 unit Run on a 15 amp circuit?

asked by: Brian

0

Expert Reply:

Yes it will; I can verify for you that a 15 amp circuit will allow you to run the 13,500 Btu Furrion AC:

- Furrion Chill HE RV Air Conditioner System - Manual - 13,500 Btu - White # FR52PR

That is the entire AC unit, or if you have a Coleman-Mach that you want to replace you can do so with the Furrion Chill Replacement RV Air Conditioner for Coleman Setup # FR82PV.

Both will work on your 15-amp circuit without any issue.

expert reply by: Kyle S

0

Answer 1

The Furrion kit part #FR67FJ and the #FR24FJ are the same except the #FR67FJ has LED mood lighting on it.

view full answer...

Answer 2

A 12V trailer power circuit will typically be wired with 12-gauge wire, part #12-1-1, but certainly there is no harm in using heavier 10-gauge wire #10-1-1. If one tow vehicle is longer than another, our installers may opt to use the heavier gauge…

view full answer...

Answer 3

Since there are a couple different questions here and I wanted to make sure that I addressed each one, I answered them individually for clarity's sake and to ensure that each of your individual questions regarding the Furrion Chill 15000…

view full answer...

Answer 4

No, you would not be able to. I have spoken with Furrion about this exact question before because their written specifications are misleading. The 14,500 BTU Furrion Chill Replacement RV Air Conditioners, like the item #FR66SR you were looking at,…

view full answer...

Answer 5

Yes, the Furrion Chill RV AC Unit part #FR25PR that you referenced does have a start capacitor built into it which is basically a soft start so that it doesn't draw as much amperage upon start up.

view full answer...

Answer 6

According to the owner's manual if your Replacement Premium Wall Thermostat for Furrion Chill HE RV Air Conditioner #FR33PR is flashing LO then that means you have an insufficient low-level 12V power supply. I recommend checking your wiring…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The Replacement Premium Wall Thermostat for Furrion Chill HE RV Air Conditioner #FR33PR isn't going to be compatible with your Coleman AC system. You would need to either switch out the system entirely with Furrion equipment or get a new…

view full answer...

Answer 9

Hey Dave, so the best option for carrying your carbon frame bike and e-bike is the Swagman Escapee part #S39SR with the ramp #S59SR . It has the capacity for carrying an e-bike, is rated for travel trailer use, only touches the bikes by the tires…

view full answer...

Answer 10

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack…

view full answer...

Answer 11

As long as the flat tow wiring is wired in before the 4-Way #C93ZV and you connect the power for the converter directly to the battery it will work. I have seen several use Magnetic Lights #TL21RK which they will wire in on the main harness to have…

view full answer...

Answer 12

The Hollywood Racks RV Rider #HLY64FR has a frame clamp design that was intended for use with step through style bike frame like what your Aventon Adventure bikes have so this rack would work perfect for you. I attached a picture that shows this…

view full answer...