Can the Timbren Axle-Less Trailer Systems be Used on the Highway

Question

Question:

can I use them on the highway?

asked by: BEN B

0

Expert Reply:

The Timbren Axle-Less Trailer Suspension System # A12RS440 that you referenced can definitely be used on the highway.

expert reply by: Jameson C

0

Answer 1

To see if any of the 2000 lb axles we offer will work for you, I'll need to know the center spring seat to spring seat distance (which you've kindly provided) as well as the hub face to hub face dimension. I've provided a diagram showing…

view full answer...

Answer 2

I may have solution for you but unforunately we don't carry an axle with those measurements. If you'd like a traditional axle you might be better off sourcing one locally so it can be ordered with the exact specs you need. Another option is a…

view full answer...

Answer 3

If you are looking for axles with 48 inches spring-center-to-spring-center length, we offer several but they have a weight capacity of 2,000 or 2,200 lbs. I have attached a link to the product page for these axles you can check out. The closest we…

view full answer...

Answer 4

The 400 pound capacity for the Timbren Axle-Less Trailer Suspension System #A4WS440 is for the set not for each. If you were to get two sets of these that would be a total capacity of 800 pounds. You would need to go up to the next highest capacity,…

view full answer...

Answer 5

The 1,200 lb weight capacity of the Timbren part #A12RS440 is the axle capacity which means the capacity of both sides together. This is a solid choice to replace a Torsion setup so this would work great for you.

view full answer...

Answer 6

We don't have an axle compatible with center of spring to center of spring dimension of 42 inches. We do however have an axle-less system that will work. I recommend the Timbren Axle-Less Trailer Suspension System with Hubs - 4 on 4 - Regular…

view full answer...

Answer 7

I recommend checking the alignment of your spindles before purchasing a new axle. Unless there is something wrong with the system itself, it may only need to be realigned. An easy way to check the alignment at home is to measure from the end of the…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Can the Timbren Axle-Less Trailer Systems be Used on the Highway

Product Page this Question was Asked From

Continue Researching