Can You Reuse The Same Cable When Replacing A Waste Valve

Question

Question:

Can the cable from the old valve be used with the new valve?

asked by: Robert S

1

Helpful Expert Reply:

Yes, the cable of your old waste valve can be used with your new Valterra Waste Valve Body w/ Flexible Cable for RV Gray Water Tank - 72" # TC172. The cable simply gets pushed into the valve body and tightened down with an Allen key (pictured below).

expert reply by: Kevin C

1

Waste Valve Cable Attachment
(click to enlarge)

Answer 1

If you're looking to just replace the valves on your gray and black tanks then the Valterra Waste Valve Bodies w/ Flexible Cables for RV Black Water and Gray Water Tanks - 72" #TC1372 you were looking at would replace the valves. These…

view full answer...

Answer 2

This is a super common question so you're not alone in not knowing the difference in the connection types. A "SPIGOT" is a piece that will slide into another fitting such as the "HUB". If you look at the picture of the elbow…

view full answer...

Answer 3

The waste valve bodies alone without a hub or spigot connection are something you can get. You would need something like the Valterra Waste Valve Bodies w/ Flexible Cables for RV Black Water and Gray Water Tanks - 72" #TC1372 for both tanks or…

view full answer...

Answer 4

The valves you are seeking to replace are made by many different manufacturers and are a standard size. The function of the valve is what you want to pay attention to as there are T-handle and cable options and then of course black water versus gray…

view full answer...

Answer 5

The Valterra Waste Valve Extension Tube with Handle #TX9HPB can be used as a replacement, but they do thread in (see accompanying photo). If you can no longer thread in a rod, you are going to need to replace your waste valve with something like the…

view full answer...

Answer 6

The Valterra Waste Valve #T1003PBC is designed to be used with a cable handle so it will work well for you.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Can You Reuse The Same Cable When Replacing A Waste Valve

Product Page this Question was Asked From

Continue Researching