Can I Get A Lock For My Anti-Rattle Hitch Pin

Question

Question:

What lock will work with the anti rattle hitch pin that comes with this bike rack?

asked by: James S

0

Expert Reply:

While I do have a solution for you, we do not have any standalone locks for anti-rattle hitch pins. I recommend the Threaded Anti-Rattle Hitch Pin Lock for etrailer Cargo Carriers - Keyed Alike, part # e99047. You will be able to use the lock that comes with this hitch pin for your motorcycle carrier # e98873.

I have included a product description link and video review links below.

expert reply by: Mark Smith

0

Answer 1

The width of the cradles on the etrailer 4 Bike Rack for 2" Hitches #e98913 measures out to 8-1/2". If the frame of your wife's bike won't allow it to fit on this rack properly then it sounds like you're…

view full answer...

Answer 2

I sure can! The correct hitch lock for the etrailer 4 Bike Rack for 2" Hitches e98913 is part #e99047. This has the threaded hitch pin so you still get the anti-rattle feature out of it. If you don't already have a cable lock then I…

view full answer...

Answer 3

Yakima racks are made in either Taiwan or China. The cargo boxes are made in the USA in Southern California. All of the Thule 4 bike racks are made in the U.S.A., but there are no Thule 4-bike racks designed for campers that can withstand the extra…

view full answer...

Answer 4

Just looking at your Tern HSD bike with fenders, I'm going to say no the Saris MHS Bike Rack for 1 Bike #SAR23MR is not going to work. I did some research and it looks like a lot of Tern owner's went with the Hollywood Racks Sport…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The Valterra Eccentric Tank Reducer, part #T1041-1, is installed with cement. When you reinstall the new one use #A05-0303. The cement is permanent so you're not going to be able to break it up. Instead you need to cut the pipes after removing…

view full answer...

Answer 7

The only motorcycle carrier we offer that is approved for use on the rear of a motorhome is the Ultra-Fab #UF48-979033. The carrier has a 500 lb capacity, but you will need to know the weight capacity of the trailer hitch you have on your motorhome.…

view full answer...

Answer 8

In most cases the Valterra Eccentric Tank Reducer - RV Gray Water - 3" Spigot to 1-1/2" Hub #T1041-1 is going to be attached to the gray water tank with an ABS solvent like #A05-0303, so it will need to be cut off in order to replace it.

view full answer...

Answer 9

I looked up the weight of your Juiced Hyper Scorpion and it weighs 90 lbs without a battery. Our bike racks aren't going to have the needed capacity so you'd need to look into a motorcycle rack like the #e98873 so that you have a rack that…

view full answer...

Answer 10

You're on the right path but this kit #34282183 has items you don't need if you're just looking to trickle charge your boat batteries. If you're just wanting to trickle charge your batteries then I recommend getting two of the…

view full answer...

Can I Get A Lock For My Anti-Rattle Hitch Pin

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching