Can TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear be Used in Place of Steps Arctic Fox

Question

Question:

Can the torklift stow and glow scissor steps be mounted on the artic fox landing in place of the steps that are on the landing.

asked by: Claude S

1

Helpful Expert Reply:

Yes you could use the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear # TLA7833 in place of the steps that are on your Arctic Fox currently.

expert reply by: Jameson C

1

Answer 1

The shipping weight of the TorkLift GlowStep Stow N' Go Scissor Steps #TLA7833 that you referenced is 29 lbs.

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…

view full answer...

Answer 5

To determine the correct Sidewinder for your 2025 Keystone Cougar 2700BH we'll need to first determine the bolt pattern. There's typically a sticker some where on the pin box or mounting ears that has a serial number, LCI item number, and RPO…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 8

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 9

Hey Jason, I spoke with Furrion and they stated that the Furrion Chill Cube is OEM only currently and should be released to the aftermarket distributors later on this year (2024), but there is no solid date. That says to me that they're probably…

view full answer...

Answer 10

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 11

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 12

Hey Jon, Yes, the Advent Air Low Profile RV Air Conditioner #ADV79FR is compatible with the Air Distribution Box #ACDB. This would have the controls on the air distribution box instead of a wall mounted thermostat. We don't currently have any…

view full answer...

Can TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear be Used in Place of Steps Arctic Fox

Product Page this Question was Asked From

Continue Researching