Is the Draw-Tite Trailer Hitch Installation the Same on a 2013 BMW X5 as the 2011 BMW X5
Question:
Is the install the same on the 2013 as it is on the 2011
asked by: Ron
Expert Reply:
The installation of the Draw-Tite Max-Frame Class III Trailer Hitch, # 75600, will be the same on the 2013 BMW X5 as it is on the 2011 BMW X5. These vehicles are part of the same generation of the X5 and BMW did not make very many changes.
I have attached the installation instructions and our installation video on a 2011 model for you to check out. You should have no problem following our video when installing this hitch on your X5.
One thing to keep in mind when installing this hitch is that you will need to remove 6 plastic push rivets to remove the rear bumper fascia. We have found that the replacement plastic push rivets included with this hitch do not fit on some X5s after 2010. You can attempt to use the included replacement rivets, but you must use rivet gun designed for plastic rivets. If the included rivets do not fit, replacement push rivets must be obtained from a BMW dealer.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 600 lbs TW
- 6000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: etrailer 2-3/4" Rise or 4" Drop Ball Mount Kit - 7,500 lbs
- Search Results: 44649
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Video: Choosing the Right Trailer Wiring
- Video: Choosing the Right Brake Controller
- Article: How to Choose the Right Trailer Hitch Class
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Search Results: 68149
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: 25580
- Q&A: Adding Brakes to a Mobile Home Axle
- Shop: Brake Controller
- Article: Trailer Wiring Diagrams
- Search Results: dust cap
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Shop: Fifth Wheel Hitch
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Search Results: dust caps
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Shop: Grease Seals 10-36 (pair)
- Video: Roadmaster Automatic Battery Disconnect Installation - 2020 GMC Sierra 1500
- Article: My Trailer Hitch Doesn't Fit
- Shop: Gooseneck Hitch