What is the Deka Jacketed 10 Gauge Brake Wiring Constructed of

Question

Question:

Is this stranded all copper wire

asked by: Tony

0

Expert Reply:

I went out to our warehouse and was able to verify that the Deka Jacketed 2 Wire, 10 Gauge, Brake Wire # 10-2-1 is stranded (braided) copper wire that is then jacketed by a high-quality plastic jacket that protects the insulated conductors.

expert reply by: Scott S

0

Answer 1

In order to add a 7 way connector on you 2020 Jeep Wrangler JL you'll need to start by adding a 4 way trailer connector like the Tekonsha #118786, which gives you the connections needed to install a 7 way connector. Once you've installed the…

view full answer...

Answer 2

Yes, the Curt Heavy Duty Forged Ball Mount #C45332 comes from Curt with the 2-5/16" hitch ball already torqued to specs. As the customer stated in their review, it must have slipped through their quality control. When we receive them and ship…

view full answer...

Answer 3

The normal color wire for electric trailer brakes is blue. It sounds like you are using regular tail light wiring, which would not be sufficient size for trailer brakes. Yellow/brown and green/brown to me sounds like parts of a wishbone harness. A…

view full answer...

Answer 4

I think you are going in the right direction. I would definitely replace the 14 gauge wire going to the trailer brake magnets with 10 gauge wire or larger. Usually larger than 10 gauge is hard to get into the trailer connector though. I would also…

view full answer...

Answer 5

I did some searching around on the internet and came up with a few interesting tips to prevent rodents from eating vehicle/trailer wiring. Here is what I found: Noise will keep the rodent's away. So a portable radio would work for this. Flashing…

view full answer...

Answer 6

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 7

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...

Answer 8

Good news! I can help you wire your 12 volt fuel pump to work with your 7 way vehicle plug. To accomplish this task you will need a few things: 7-way plug #A7WCB 10 gauge wire #10-2-1 2 pole flat wiring #HM47965 butt connectors #DW05745-5 First thing…

view full answer...

Answer 9

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 10

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

view full answer...

Answer 11

For your 2024 Toyota Sienna Platinum you will need a 7-way connection along with the brake controller itself. I recommend the following: -Curt Powered Tail Light Converter #C59236 -Universal Installation Kit for Trailer Brake Controller #ETBC7…

view full answer...

What is the Deka Jacketed 10 Gauge Brake Wiring Constructed of

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching