Replacement Axle for Quality Trailer Products Model TS70

Question

Question:

What is the correct Dexter replacement for Quality Trailer Products axle TS70, 7.0k rating, 95 HD80 SC? Can I transfer hub and brakes?

asked by: Scott P

1

Helpful Expert Reply:

We have a 7k Dexter axle that would work perfectly to replace your Quality Trailer Products axle TS70, 7.0k rating, 95 HD80 SC with the part # 8327834 as it matches all capacities and dimensions. Your current hubs and assemblies would transfer over as well.

expert reply by: Jameson C

1

Answer 1

A tandem axle trailer suspension's equalizers like #TREQE1 should install with the single center hole at the top, where it attaches to the center hanger. This can be seen in the linked diagram taken from our article on double-eye trailer…

view full answer...

Answer 2

We have a bearing kit for the Dexter 7k trailer axle #8327834 with the part #BK3-200 which comes with bearings 14125A and 25580 and seal 10-36.

view full answer...

Answer 3

In order to change from an 7,000 pound axle to an 8,000 pound axle you will need to replace the entire axle with an 8K model. You will not be able to add any parts to your current axle to upgrade it to an 8,000 pound capacity. We do not currently…

view full answer...

Answer 4

The bushings for the slipper springs in your Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers - Tandem 7K Trailer Axles #RM-2460-2570 would not need grease so you can definitely swap out the wet bolts with some standard bolts…

view full answer...

Answer 5

If you need an axle replacement because one is damaged, you will be fine sticking with the 7,000 lb axles you currently have. All you would need to do is get the hub face to hub face measurement to choose the right axle length. We have 94"…

view full answer...

Answer 6

Yes, the Roadmaster Comfort Ride system part #RM-2460-2570 would fit your 2019 Fuel 335 Toy Hauler. It would do a great job improving the ride quality.

view full answer...

Answer 7

Jounce springs will sit on the frame and come into contact with the axle as the suspension compresses. Typically the vehicle manufacturer will place a rubber-type material here to prevent the harsh bump between these two components when heavily…

view full answer...

Answer 8

Assuming your tires are in good shape without any bulges the easiest way to determine if you have a bent spindle is to take a straight edge that is longer than the tire and lay it across the tire parallel with your trailer frame and then measure the…

view full answer...

Answer 9

I spoke with my contact at Ventline and she stated that if you have a newer EZ Lift Ventadome, the correct replacement lid will be part #BVE0108-03. This smoke color lid features a plastic hinge with four mounting points. You can compare the hinge…

view full answer...

Answer 10

Each of the leaves on the Leaf Spring #e47SR are 3/8" so this will give the spring pack a height of 1-1/2". Here is a list of our U-Bolt Kits for a 3" axle. Redline #APUBR-9 Dexter #APUBR-8 CE Smith #CE23003

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement Axle for Quality Trailer Products Model TS70

Product Page this Question was Asked From

Continue Researching