Replacement Brackets and Rails for Solera Awning  

The Replacement Mounting Hardware part #LC701665 comes with the Extension Rods, Extension Rod Bracket, Torsion Arm Caps, and various hardware. I am not sure what all you have now but it sounds like you might also need the torsion heads, part…

The Solera Slide Topper Access Kit part #LC795354 includes the "cover" for the main screws. The main screws attach to the small bracket and you camper. The larger portion of it slides over the screws "covering"…

I recommend replacing the Extension Rod for your slide topper. With your current rod being bent even if you were able to bend it back straight it will more easily bend in the future or could break. We have the following extension rods for the…

Yes, the Replacement Awning Extension Rod for Solera Slide-Topper Awning #LC3452072 that you referenced measures 3/4". I actually recently took this same measurement for another customer for the white version part #LC3452071 and I'm…

I have a solution for you, but my contact over at Lippert tells me that you won't be able to replace just those casings on Solera Slide-Out Topper. The parts you need are the Replacement Idler Head and Roll Tube for Solera RV Slide-Out Awning -…

Replacement Mounting Hardware for Lippert Solera Slide Topper - Black #LC701665 uses #10 - 16 x 3/4” screws to secure the shaft of the extension rod bracket. I've attached a photo to assist.

The screws that are part of the hardware cannot be purchased separately from the Replacement Mounting Hardware for Lippert Solera Slide Topper #LC701665. Those screws are only with this kit.

I contacted the manufacturer about the proper installation of the Replacement Idler Head and Roll Tube for Solera RV Slide-Out Awning #LC87FR. It should be installed approximately 5-6 inches away from the side of the camper (slide topper opened…

You do not have to remove the entire slide topper to be able to replace the Idler Head and Roll Tube #LC87FR for your Solera slide topper. A second person will be able to support the weight of the tube and fabric in place while the assembly is…

For replacing the Drive Head #LC34FR and Idler Head #LC87FR on a Solera Slide Topper you will want to completely remove the slide topper from your RV/Camper. You will need to insert a pin into the end of the tube end cap(see image) to keep the…

The amount of times you'd need to wind a Solera awning when installing it is 14 times. The part number you have 285148 matches up with the #LC87FR.

The Replacement Drive Head and Roll Tube #LC34FR is the correct assembly for the right hand side of your Solera Slide topper as you stand facing it from outside the camper. The Replacement Idler Head and Roll Tube #LC87FR is on the left hand side as…