How Is The LED Trailer Dome Light with Switch Installed

Question

Question:

How do you get the ring off to surface mount the light? Regards,

asked by: Olson P

0

Expert Reply:

The LED Trailer Dome Light with Switch - Surface Mount, # 3375625337 has three small screws on the back to remove the base from light fixture.

expert reply by: Michael R

0

Answer 1

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 2

For starters, a breakaway switch will need to have a separate and independent battery according to most state regulations so it may be beneficial to check with your local DMV or DOT before proceeding. The Hopkins Engager Push-To-Test Trailer…

view full answer...

Answer 3

Most Break away systems will have an integrated charger but not all of them do. I've attached a wiring diagram of the difference so you can compare your system. The best way to tell is to check out the wiring and use a multimeter like #PT89ZR to…

view full answer...

Answer 4

We can definitely help get you going in the right direction with how to do the wiring as well as parts you may need. For the most part on the trailer it will be running a power wire like part #10-1-1 (sold by the foot) to all of the light assemblies…

view full answer...

Answer 5

No problem. If your existing trailer interior lights use a 1-wire hookup this means they use their mounting hardware to make the ground connection and the single lead is the +12V feed. Adding more high-efficiency LED lights with 2 wires will only…

view full answer...

Answer 6

The Gustafson RV Puck Light, 5" Surface Mount with 18 LEDs at 4 Watts #277-000341 is a 12V light that is installed in a circuit either singularly or in multiples. The circuit will require a switch and is compatible with a dimmer switch. However,…

view full answer...

Answer 7

Due to the importance of a properly functioning break away system, it would be best to leave the existing break away battery in place and add an additional battery for powering the jack. A standard automotive or small deep-cycle 12 volt battery would…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

How Is The LED Trailer Dome Light with Switch Installed

Product Page this Question was Asked From

Continue Researching