Can HappiJac Truck-Mounted Camper Tie-Downs LC182908-182928 be Ordered Without Stabilizer Bar

Question

Question:

Can I order this kit but dont need the rear mounts and the long bar ? How much $$ for this kit ?

asked by: Martin Y

0

Expert Reply:

The HappiJac Truck-Mounted Camper Tie-Downs # LC182908-182928 cannot be ordered without the rear mounts and stabilizer bar, they are included in the kit.

The price can be found directly on the product page.

expert reply by: Kyle S

0

Answer 1

In regards to HappiJac Truck-Mounted Camper Tie-Downs like part #LC182908-182928, the front tie-down installs inside the bed on the front panel directly behind the cab. The rear tie-down then mounts to the bumper. They will not require removal of the…

view full answer...

Answer 2

We have exactly what you're looking to fit your 2003 Dodge Ram 3500 dually with the 8ft long bed and a factory hitch. Have a look at the HappiJac Custom Tie-Downs for Truck Bed Camper #LC182908-182928 which are the front and back tie downs custom…

view full answer...

Answer 3

The HappiJac Truck-Mounted Camper Tie-Downs #LC182908-182928 does come with the stabilizer bar. I've included a video showing the contents of this product so check that out!

view full answer...

Answer 4

We do have a HappiJac set of camper tie downs that do fit your 2004 Dodge Ram 2500 long bed with the part #LC182908-182928 but the part number you mentioned does not fit and would not work.

view full answer...

Answer 5

The support braces in the HappiJac Truck-Mounted Camper Tie-Downs #LC182860 are going to attach to the cross frame to provide support for the anchors which will bolt through the bed wall and into the braces. The rear anchors will bolt through the…

view full answer...

Answer 6

Jounce-style helper springs are easier to install than air bags since they're less parts involved. Also, once they are installed you basically leave them alone. Air bags need to have the air pressure monitored and changed according to the load…

view full answer...

Answer 7

HappiJac does offer a tie down set that fits your 2008 Dodge Ram 2500 Mega Cab with the part numbers #LC205220-205221 but the #LC182908 does not fit your truck.

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

view full answer...

Answer 11

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 12

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Can HappiJac Truck-Mounted Camper Tie-Downs LC182908-182928 be Ordered Without Stabilizer Bar

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching