WIll the Replacement Hardware Kit for Fulton Swivel Jacks # F0933325S00 Fit any Jack?
Question:
Is this hardware kit specific to only Fulton jacks or will it work with any standard jack? Thanks.
asked by: Chris M
Helpful Expert Reply:
The Replacement Hardware Kit for Fulton Swivel Jack # F0933325S00 is a direct replacement from Fulton that is designed to fit only Fulton-model swivel jacks. However, there is a possibility that you will be able to use the hardware for your specific jack. The length of the bolt is 1-1/2 inches. As far as the bushing, it has an outer diameter of the bushing is about 1-1/8 inches, an inner diameter of 5/8 inch, and 1/2 inch deep. The nut is 3/4 of an inch wide. I went ahead and attached a video to this answer that explains these dimensions as well.
In order to know for sure if the hardware will fit your jack, I recommend measuring the bushing insertion point to see if it is compatible with the measurements of the Fulton Swivel Jack replacement hardware.
Product Page this Question was Asked From
Replacement Hardware Kit for Fulton Swivel Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Sleeve Washer for Fulton Swivel Jack to Prevent it From Leaning
- Video: Review of Fulton - Trailer Jack,Camper Jack - F0933325S00
- Q&A: Replacement Washer Needed for Fulton Swivel Trailer Jack
- Q&A: Replacement Bracket Metal Bushing for Fulton Swivel Jack
- Q&A: Direction of Tapered Nut When Installing Replacement Hardware Kit for Fulton Swivel Jack
- Shop: Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Q&A: Fulton Trailer Jack Replacement Hardware Kit
- Q&A: Dimensions of the Round Bushing Included with Fulton Jack Replacement Hardware Kit # F0933325S00
- Shop: Replacement Cap for etrailer and Ram Swivel Marine Jacks - 1,500 lbs
- Shop: Replacement Endcap for Fulton Round, Swivel Marine Jacks
- Shop: Replacement Endcap for Fulton Bolt-Thru Swivel Marine Jacks with 2" Tubes
- Q&A: Does Race Need To Be Replaced If Installing New Bearings
- Shop: Dexter Trailer Hub and Drum Assembly for 3,500-lb E-Z Lube Axles - 10" Diameter - 5 on 5-1/2
- Shop: Steel Directional Trailer Wheel - 13" x 4-1/2" Rim - 5 on 4-1/2 - Chrome Finish
- Article: Most Popular Wheel Bearings
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Shop: Trailer Hitch
- Search Results: 25580
- Shop: Trailer Wiring
- Search Results: trailer jack
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Search Results: l68149
- Shop: Brake Controller
- Video: Fulton Round Snap Ring Swivel Marine Jack Review
- Shop: Gooseneck Hitch
- Search Results: l44649
- Video: Choosing the Right Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Accessories and Parts
