How Low Below Door Does Westin Nerf Bar # 21-53565 Install

Question

Question:

How far do they down from bottom of door.

asked by: Brian

0

Expert Reply:

We don't have a way to get you that exact figure but I attached a picture that shows the Westin steps part # 21-53565 installed and you can see the clearance to get an idea.

expert reply by: Jameson C

0

Bars Installed
(click to enlarge)

Answer 1

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 4

As long as the RBW Lil' Rocker mounts to industry standard base rails you'll need the Curt Adapter Rails #C29BR that fit in the OEM puck system on your 2019 Ram 2500 and give you a standard base rail connection. I'm attaching a photo…

view full answer...

Answer 5

To replace the motor on the LCI Pump 650057 we have the Replacement Motor #LC167576.

view full answer...

Answer 6

The factory prep package or pucks are not the same between Ram, GM and Ford. The spacing is all different which means you cannot use a 5th wheel hitch for Ram pucks on a GM with pucks. Take the Curt A25 5th Wheel Trailer Hitch for example which is…

view full answer...

Answer 7

Because your trailer has a Turning Point pin box and your Ram has a 6.5' bed I do recommend going with a fixed hitch and using the Turning Point as a rotating pin box to give yourself enough turning clearance. With you also having a puck system…

view full answer...

Answer 8

Most standard pin boxes will not make a 90 degree turn in anything less than an 8 foot truck bed, but that is due to being too close to the cab - not the rails. You mentioned you wanted to replace the Rota-Flex with the Gen-Y hitch. Your old pin box…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 11

The height of the B&W Companion OEM 5th Wheel Hitch for Ram Towing Prep Package #BWRVK3600 would be from the bed to the top of the hitch plate. This is to meet up with the pin box on the fifth wheel so that it rides level while you tow for better…

view full answer...

How Low Below Door Does Westin Nerf Bar # 21-53565 Install

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching