Install Instructions For Door Magnet On Lippert Electric Tread Lite Steps

Question

Question:

How are the magnets suppose to be aligned? Can I get a picture? Thanks

asked by: Steve C

0

Expert Reply:

The easiest way to do this is to replace the original magnet with the new magnet. If you don't have a magnet already, start with the motorhome side first, see where the door lands and apply your new magnet to the door with the provided adhesive tape.

I have included a picture to help guide you. I will also link an install video.

expert reply by: Bryce D

0

Orignal Door Magnet Location with New Magnet In Hand
(click to enlarge)

Answer 1

To begin you will want to begin testing the different circuits of the Step Control Module #LC334850. The brown wire goes to the door switch to tell the steps when to open and close. The yellow wire runs to an ignition switch so that the steps know…

view full answer...

Answer 2

The warranty on the steps is 1 year. I actually am in the process of getting the replacement motor for this kit on our site but am waiting on pricing info based on your previous question. It could be the sensors on the door of your RV…

view full answer...

Answer 3

The 334850 part number you mentioned refers to the Replacement Control Switch #LC334850. This particular unit replaces the control switch assembly for certain Lippert Tread Lite RV Steps ( #LC353542, #LC353543, #LC353620, or #LC353621).

view full answer...

Answer 4

Based on what you described it does sound like the module is bad and would need to be replaced. The correct replacement would be the part #LC334850 that you referenced.

view full answer...

Answer 5

Here's the recommended way to troubleshoot RV Coach Steps that aren't working properly. 1. Disconnect the plug between the chassis and the steps. Using a voltmeter, measure the voltage on the large red wire at the chassis connector with the…

view full answer...

Answer 6

The Replacement Control Module for Lippert Electric Coach Step #LC301702 is the correct fit for your Lippert Coach step. The long green wire with the ring terminal is your ground and will be attached bare metal to metal on our coach frame. The short…

view full answer...

Answer 7

It could be the sensors on the door of your RV that's either failed or fallen off. You might check there to verify that the magnets are there and working properly. These sensors basically are what tells the steps your door is open or closed and…

view full answer...

Answer 8

This can be a number of possibilities why your Lippert Electric Tread Lite Step for RVs #LC353543 are not working properly, sometimes, the steps will not retract if the door and door frame magnet switches aren’t perfectly aligned. These components…

view full answer...

Answer 9

The replacement motor you need is the #LC183058 for the Lippert Tread Lite steps #LC353543 that you referenced. It could be the sensors on the door of your RV that's either failed or fallen off. You might check there to verify that the magnets…

view full answer...

Answer 10

We do have a wiring diagram for the Lippert Components Kwikee Step Rocker Switch #LC371010. I have attached a clip from the installation instructions that demonstrates how to wire this for you to check out.

view full answer...

Answer 11

For a double step that is 24 inches wide and is a manual pull out step we have the part #SMFP-2100 which is pretty similar to the #LC353543 without the motor.

view full answer...

Answer 12

I spoke to my contact at Lippert and they informed me that you need to check that you are getting 1.5 to 3 amps coming from the control module. If you are, then test the brake by adding power and ground to the brake leads. (polarity doesn’t matter).…

view full answer...

Install Instructions For Door Magnet On Lippert Electric Tread Lite Steps

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching