Does the Viking Solutions Adjustable Fishing Rod Carrier Fit Different Size Truck Beds

Question

Question:

Hi Can it it be less is width coz the size is to big for my ram limted

asked by: Khalifa A

1

Helpful Expert Reply:

The mounting brackets on the Viking Solutions Adjustable Fishing Rod Carrier for Truck Beds - Aluminum - Black - 6 Rods # VS54FR have 4 different adjustment positions to allow you to fit this on most full sized or compact trucks. The brackets can be adjusted between 56" and 62" (inside the bed), but if your bed is more narrow than 56" the only bed mounted rod carrier we have available that would work is the RodBunk Deluxe Fishing Rod Carrying System for Truck, SUV or Van - 30" to 65" Long # IMF17727.

I've linked some review videos of these for you to check out as well.

expert reply by: Erik B

1

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Hey Tim! Yes, the Rhino-Rack Ski and Fishing Rod Carrier #RR572 will fit the older Thule square crossbars. While this kit does come with T-Slot hardware, it also has the clamps which is what you'll use for the square crossbars.

view full answer...

Answer 4

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 5

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

You ask an interesting question. If your 2017 Jeep Grand Cherokee has the factory-installed trailer sway control (TSC) system already and you are also using a mechanical weight distribution/sway control hitch system I do not recommend adding a third…

view full answer...

Answer 8

The BTR and BT8 denotations refer to the spindle, not the trailer hub. The difference between a BTR and BT8 spindle is that the BTR spindle uses a 1.063" diameter L44649 bearing and the BT8 spindle uses a 0.99" diameter L44643 bearing. In…

view full answer...

Answer 9

The Yakima Replacement T-Bolt with Nut for Yakima Rack and Roll Trailers - Qty 4 #Y8880184 will fit in the channels of your HD bars, but for the most part, crossbar mounted accessories will come with (or have available) T-channel hardware that will…

view full answer...

Answer 10

While we do have some T-Bolts #RR72XB which will fit into the TS Rails for TruXedo Elevate Rack System #TH65FR. I recommend using the hardware which comes with the Tie-Down Kit #TH52FR since the kit comes with 8 T-Bolts as well as washers and nuts.…

view full answer...

Answer 11

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 12

Customer Brad is using kayak rollers on his Thule Goalpost TH997. There are several options for these. You can get a set of 4 from Yakima using #Y04082-2 or a pair using #Y04082. I have linked a video of these rollers for you.

view full answer...

Does the Viking Solutions Adjustable Fishing Rod Carrier Fit Different Size Truck Beds

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching