Will the Replacement Ball Assembly # UF19-001057 Work with the Ultra-Fab 5th Wheel Tripod Stabilizer

Question

Question:

Will this work with Ultra-Fab UF19-950600?

asked by: Patrick C

0

Expert Reply:

Yes, I confirmed with Ultra-Fab that the Replacement Ball Assembly for Ultra-Fab Gooseneck Tripod Stabilizer UF19-001057 will work with the Ultra-Fab 5th Wheel King Pin Tripod Stabilizer # UF19-950600.

expert reply by: Bob C

0

Answer 1

The Replacement Ball Assembly #UF19-001057 that you referenced can be used with an Andersen Ultimate fifth wheel adapter but it has to be used with an Ultra Fab stabilizer like the #UF19-950500 since we can't guarantee it would work on an…

view full answer...

Answer 2

The Ultra-Fab Economy 5th Wheel King Pin Tripod Stabilizer - Steel - 31" to 54" - 5,000 lbs #UF19-950500 will not fit with the attachment for your Andersen Ultimate in place. However, if you want to keep that hitch attachment in…

view full answer...

Answer 3

Yes the Replacement Gooseneck Ball Assembly #UF19-001057 you were looking at will fit the Ultra-Fab 5th Wheel King Pin Tripod Stabilizer - Steel - 37" to 50" - 5,000 lbs #UF19-950001 you were looking at perfectly. I included videos…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 6

Ultra-Fab products like the Ultra-Fab 5th Wheel King Pin Tripod Stabilizer - Steel #UF19-950600 are made in Elkhart, Indiana.

view full answer...

Answer 7

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 8

We have had confirmation that the 2018 GM factory fifth wheel rail kit is the same as the 2017 so if you had a short bed truck you'd want the slider Companion part #BWRVK3770 or if you had a long bed truck you'd want the part #BWRVK3700. The…

view full answer...

Answer 9

The formula you used is only a guess and wouldn't be an accurate way to determine your trailer's actual pin weight since it's a triple axle toy hauler. The only way to get an accurate number would be to measure at highway weigh station.…

view full answer...

Answer 10

For a brake controller I would recommend the Prodigy P3 Brake Controller part #90195 for basically every towing situation but especially for an electric over hydraulic setup like what you have. This is our best selling brake controller because of how…

view full answer...

Answer 11

Thanks for the info you listed. Based on that the correct replacement motor is the part #LC295380.

view full answer...

Will the Replacement Ball Assembly # UF19-001057 Work with the Ultra-Fab 5th Wheel Tripod Stabilizer

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching