MaxxAir Remote Control For 8500K Series Intake and Exhaust Fan

Question

Question:

Im looking for a remote control compatible with the Maxxair 8500K model. It is an intake/exhaust fan, s/n 2017-02-8500K-A00010. Thank you!

asked by: Lee

1

Helpful Expert Reply:

The Replacement Handheld Remote # MA00A01150K will work with your MaxxAir 8500K fan you already have.

The remote is optional and not listed in our description for 8500K fan. To use the remote you will simply turn on the remote and it will communicate directly with the fan. There is no pairing or linking procedure required for the remote.

expert reply by: Bud M

1

Answer 1

I spoke with my contact at Lippert regarding your existing motor/gearbox model 5973820. He stated that the correct replacement motor is the Lippert Components Kwikee Step Motor Replacement Kit #LC379608. This is a direct replacement for the motor…

view full answer...

Answer 2

Replacement Operator Mechanism for MaxxAir MaxxFan Plus or MaxxFan Deluxe Roof Vents #MA10-20281K-1AF is what you want for your MaxxAir Deluxe Fan if it is a power lift or the Replacement MaxxAir Roof Vent Manual Lift Operator #MA10-20281K-3CF if it…

view full answer...

Answer 3

If your MaxxFan Plus Roof Vent #MA00-04000K isn't responding at all to the remote then most likely it just needs to be replaced with part #MA00A01150K or the batteries are just in need of a change. I do also recommend verifying that you're…

view full answer...

Answer 4

Roof vents with fans like the MaxxFan Roof Vent w/ 12V Fan #MA00-04000K do not have a fuse anywhere in the fan itself. You will want to use a circuit tester like #PTW2993 to see if there is power getting to the fan. If it was installed by the…

view full answer...

Answer 5

My contact at MaxxAir advised that there are three potential causes for the beep and no fan motion you're experiencing with your MaxxFan Trailer Roof Vent #MA00-04000K. One potential cause is that the unit was wired with incorrect polarity. Make…

view full answer...

Answer 6

Since you've already verified the batteries are good, and that the buttons on your MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat #MA00-05100K are working properly, then you may just have a bad remote. To replace your remote, you can use the:…

view full answer...

Answer 7

I spoke with my contact at MaxxAir who said that if you lost the remote to your MaxxAir fan there is no programming that has to be done when using a replacement remote. Part #MA00A01150K is already compatible with all MaxxAir fans that have…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

MaxxAir Remote Control For 8500K Series Intake and Exhaust Fan

Product Page this Question was Asked From

Continue Researching