Correct Replacement Rear Electric Stabilizing Jack for Keystone Everest 5th Wheel

Question

Question:

Recommend the product I need to replace my current jack. Will it be an exact replacement?

asked by: Ron B

0

Expert Reply:

I am not sure what rear electric stabilizer jack a Keystone Everest 5th Wheel uses but if it's a Lippert product then the Lippert High-Speed Power Stabilizer Jack part # LC298707 is likely the correct replacement. It will wire up to the existing switch or you can use the one that comes with and should bolt on using the same holes as the old model.

expert reply by: Conner L

0

Answer 1

The Lippert High-Speed Power Stabilizer Jack part #LC298707 would be an excellent replacement option for the now discontinued 337199 model. It does come with a new switch so you can either wire this up or reuse the existing, either way the switch…

view full answer...

Answer 2

Unfortunately, there are no replacement legs available for the Lippert Power Stabilizer Jacks like #LC298707, you'll need to replace the whole assembly. It's a good idea to replace the whole unit when there is significant damage.

view full answer...

Answer 3

This has been a topic of conversation we have had in the past and verified with the manufacturer, and they've confirmed that a bent/broken leg is not replaceable, unfortunately. The only solution is to replace the entire assembly with the Lippert…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 10

I attached a picture that shows the install instructions for the Lippert Components High-Speed Power Stabilizer Jack #LC298707 that you referenced and in it you'll notice a set distance isn't specified for where it has to install on the…

view full answer...

Answer 11

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

view full answer...

Answer 12

The direct replacement for your Lippert Model 113407 stabilizer jack is part #LC369774. I confirmed this with my contact at Lippert. It requires an easy bolt-on installation.

view full answer...

Correct Replacement Rear Electric Stabilizing Jack for Keystone Everest 5th Wheel

Product Page this Question was Asked From

Continue Researching