Parts Needed to Tow a Small Trailer w/ Motorcycles and/or Kayaks w/ a 2017 Ford Edge SEL  

Question:

Expert Reply:

In addition to the Draw-Tite Max-Frame Trailer Hitch Receiver # 75234 for your 2017 Ford Edge SEL you will also need a Tekonsha T-One Vehicle Wiring Harness # 118669. This will give you a 4-way flat wiring connection that is commonly used on most small trailers.

The Draw-Tite Receiver # 75234 measured in at 5-1/2" for the hitch pin center hole to the rear bumper of a similar Ford Edge when installed in our shop. The inside top edge of the receiver was 12-1/2" from the ground as well. This will help you to determine how much height is needed for a ball mount.

The Curt Ball Mount # D-4 will give you 3/4" rise or 2" of drop Hitch Pin and Clip, # PC3. You will need to measure the height of your trailer coupler to ensure that you get the correct height ball mount. Also your 2" Ball # 63845 has a certain shank diameter that will need to match the ball mount. In this instance both of these have a 1" shank. If you need help finding the correct size please let me know what your measurements are.

If you do not have the trailer yet the etrailer Ball Mount Kit # 989900 includes 2 different height ball mounts, 2" ball, 1-7/8" ball, 2 hitch pins and a convenient carry bag to keep everything in one place.

I recommend using a Master Lock Trailer Hitch Receiver Lock and Coupler Lock Set # 3794DAT as it has locks for the ball mount, coupler latch and a storage lock for the coupler that will keep your trailer secured when you are away from it and your Edge.

expert reply by: Bud M

0