Correct Replacement Front Landing Gear Leg for Jayco Seismic 310 with Lippert Auto Level System

Question

Question:

2015 Jayco Seismic 310 w toy hauler front left auto laving jack replacement jack.

asked by: Richard

0

Expert Reply:

The correct replacement front landing gear leg for a Jayco Seismic 310 with Lippert Auto Level System is the Replacement Front Jack for Lippert Ground Control 3.0 Leveling System part # LC362485.

expert reply by: Conner L

0

Answer 1

For front leg replacements for the Lippert Ground Control systems we have the part #LC362485 for just the leg portion or the part #LC305340 for a leg with the foot and motor as well. These will be the same length as what you have currently.

view full answer...

Answer 2

The distance between the insides of the weld stops on the jack leg #LC362485 is 17-1/2 inches and the outer tube diameter is 2-1/2 inch by 2-1/2 inch.

view full answer...

Answer 3

Based on your troubleshooting efforts my contact at Lippert thinks there may be a bend in the right front jack leg of your Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC358590. Since the jack struggles with motor power but works when…

view full answer...

Answer 4

You have a Lippert Ground Control 6 point kit installed on your RV and the best solution to fix what you have is the part #LC362485. This is the replacement leg portion without the motor for the front of the setup like you are needing. Lippert does…

view full answer...

Answer 5

Thank you for the picture with the measurement of your current Lippert Ground Control right rear leg that measures 24-1/2 inches from top to bottom when retracted. Based on that the correct replacement is the part #LC344792 and not the one you…

view full answer...

Answer 6

The correct Replacement Right Rear Leg for Lippert Ground Control 3.0 Electric Leveling System is part #LC428493 for 22-1/2" or part #LC344792 for 24-1/2". I don't have any way to look up which you need so you can either measure or call…

view full answer...

Answer 7

I wish we offered the front legs of the Lippert Ground Control 3.0 without the motor but the only solution we have is the #LC305340 which includes the motor and the leg.

view full answer...

Answer 8

No, the hall effect motor does not have to be greased, but per the service manual if the jacks are down for an extended period, it is recommended to spray the exposed leveling jack tubes with lubricant every 3 months for protection. If you live in a…

view full answer...

Answer 9

In regards to the Lippert Ground Ground Control 3.0 Leveling System, if you just need a new front leg then this can be replaced with the Replacement Front Jack for Lippert Components Ground Control 3.0 Leveling System part #LC362485. If you need a…

view full answer...

Answer 10

I wish we had just the leg portion of the Replacement Lead Leg #LC305340 but at this time the only way to get it is with the #LC305340.

view full answer...

Answer 11

In regards to the Lippert Ground Control 3.0 Leveling System (what you were looking at), there are no replacement inner tubes available. Therefore, if you bent the inner tube on the front leg then you will need to replace the entire leg for which we…

view full answer...