Replacement Wheel Bearings, Races and Grease Seal For a 1999 Coleman Sea Pine Tent Trailer

Question

Question:

Looking for part number, price and availability for wheel bearing kit

asked by: Paul H

0

Expert Reply:

We offer all the components you will need to replace your wheel bearings on your 1999 Coleman Sea Pine, but it is not available as a kit.

Wheel Bearing # L44649 quantity 4
Wheel Race # L44610 quantity 4
Grease Seal # 13194 quantity 2
Cotter Pin # 165649 quantity 2
Grease Cap # F001518 quantity 2

The Bearing Buddy Bearing Protectors # BB1980A-SS are a great alternative to the grease caps as they will allow you to add grease to your hub without removing the wheel hub.

expert reply by: Bud M

0

Answer 1

We most likely have the bearings you will need for your trailer, but we don't have the specific bearing info for your trailer. I really wish there was a way to determine what bearings a trailer needed without actually pulling the wheel off…

view full answer...

Answer 2

The overall size of the Furrion Over the Range RV Convection Microwave part#FMCM15SS is 29-15/16" wide x 16-3/8" tall x 15" deep and requires a 30" cutout. If this matches the opening and size of the model you have…

view full answer...

Answer 3

For a standard replacement equalizer for your Dexter 13-122 equalizers you'd want the #TREQE1 or for a cushioned version you'd want the part #K71-653-00 which comes with new shackles and bolts. For a kit that includes new bolts, bushings, and…

view full answer...

Answer 4

I looked up the dimensions of your High Pointe EC942K9E and it's 15 inches deep, 15.7 inches tall, and 29.9 inches wide so the Furrion Over the Range RV Convection Microwave #FMCM15SS would easily fit in place of it and would also work really…

view full answer...

Answer 5

I believe you are referring to the XTRM Universal Sealant #34427034145-1. If so, it can absolutely be used in place of the original XTRM 100 that was on your roof. This will work just as well as the original sealant and its weather-resistant formula…

view full answer...

Answer 6

The LaSalle Bristol XTRM Self-leveling Sealant part #34427034145-1 is very comparable to the Dicor 501LSW self leveling lap sealant. I can't say exactly what the formula is for Dicor but I can tell you that LaSalle Sealant is a silicone sealant…

view full answer...

Answer 7

Based on the photo and information you provided, I can tell you have 12 x 2 inch Dexter brake assemblies for 5.2K axles, for which the Electric Trailer Brake Kit #AKEBRK-7-SA will be an excellent replacement. These are self-adjusting brakes so they…

view full answer...

Answer 8

The brake assemblies you have are 7k Dexter assemblies that are 12 inch by 2 inch in size. The part number #AKEBRK-7-SA will work as a great replacement set. This includes assemblies for both sides of your trailer that are self adjusting.

view full answer...

Answer 9

If the two 6 volt batteries were wired in series to produce 12 volts total then a 12 volt battery would easily work as a replacement for them. If the two batteries were wired in parallel and the output voltage is 6 volts then no. I attached a diagram…

view full answer...