Is the LED Trailer Clearance or Side Marker Light MCL32AB Offered In Red

Question

Question:

I found the amber one you suggested to replace it but cannot find the red lens

asked by: Johnny R

0

Expert Reply:

The LED Trailer Clearance or Side Marker Light is offered in both amber as part # MCL32AB and red as part # MCL32RB. These are a pretty standard design so they are a common replacement for both older and newer trailers. Simply attach the power and ground wire at the rear, pop-off the lens, secure the base, then re-secure the lens and you're done.

expert reply by: Conner L

0

Answer 1

The SAE-P2-A98 that you are referring to is actually tied to different tests that have been done on the light and doesn't reflect the part number of the light itself. We have found that a good number of customers have replaced lights with the…

view full answer...

Answer 2

The part #MCL32AB and the #MCL32RB do not come with gaskets. But you could use sealant like part #0160297 to make one if you needed.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 12

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

view full answer...

Is the LED Trailer Clearance or Side Marker Light MCL32AB Offered In Red

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching