Correct Bearings for AL-KO Axle On Palomino Pinto Trailer  

The Bearing Kit, L44649 Inner/Outer Bearings part #BK1-150 is designed for 2,200 lb axles with a 1.063" bearing diameter so if this is what you have then it will be a great fit.

You can check the condition of your hub's races by carefully removing all bearing grease with a rag to expose the actual surface of the races. When they are completely free of grease, etc., inspect them for any signs of scoring (very slight…

Based on your seal dimension being 1.5 inch and your bearing dimension of 1.06 inch on your spindle the correct bearing kit you need is the part #BK1-150.

EZ Lube Dust Caps, like #DC200L-DCRP, have a rubber plug that can be removed to access the zerk fitting. The rubber plug can be removed by gently prying it up with a flathead screwdriver. If your dust cap is in good condition and you want to avoid…

Trailer tires and wheels do not typically come balanced from the factory like what you see with standard passenger vehicle tires. This isn't usually needed for trailer tires and most car shops don't have the needed setup to properly balance…

We have a few bearing kits that could potentially work for your utility trailer, but we first need to determine what you have on your trailer so that we can pick out the correct parts. What you would need to do is remove a current hub and get the…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

The TruRyde Spindle Nut #165686 has an outer measurement of 1.45 inches. You will use a 1-1/2 inch socket on this castle nut or we usually use a channel lock for these installations. I've attached a video of an installation of a hub to assist.…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…