Installing Redarc Tow-Pro Brake Controller on 2008 Ford F150

Question

Question:

I have a 2oo8 f15o with a factor 4 blade. Had a rv 7 pole added. Will the redarc tow pro elite code red44fr and plug adapter red87fr work for my truck. I think the controller and controller wiring is part number code red44fr . Red87 . thank you.

asked by: Pat B

0

Expert Reply:

Assuming that your 7-way was tied into the brake output circuit at the factory connector on the driver's side frame rail, all you'll need to install the Redarc # RED44FR Tow Pro Elite is the Ford # RED87FR wiring harness that will plug into the connector under the dash. The connector is located above and to the right of the OBDII connector, above where the driver's right knee would be, as shown in the linked install video. The video shows a different controller being installed, but you'll still find the video helpful. I'll also link to a video that explains the features of the controller and how it works.

The Tow-Pro Elite is a dual-mode controller, which means that it can work both as a proportional and a time-delayed controller (what Redarc refers to as User Controlled Mode). To be honest with you, unless you'll be towing in rough off-road conditions, you'll never need the user controlled mode. You'll be better off going with the less expensive Tow-Pro Liberty, part # RED24FR which installs in the same manner and operates proportionally only. There's no reason to pay extra for a feature you likely won't ever use.

expert reply by: Mike L

0

Answer 1

All you need to install the Prodigy P3 #90195 in your 2005 Ford Excursion with the factory 7-Way is the install harness part #RED87FR.

view full answer...

Answer 2

The 7-way wiring harness kits offered for your 2008 Ford F-150 are shown on the linked page and all include both the wiring harness portion and the trailer connector as well, such as PK11893-11932 from Pollak. Both of these use a standard round U.S.…

view full answer...

Answer 3

To install the Redarc Tow Pro Liberty #RED24FR in your 2016 Ford F-150 all you need is the correct install harness part #331-TPH-007 which plugs in under the dash. You do not need to do any programming of the vehicle for this to be active and…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 10

Hello Tim. We can definitely set you up with a complete AC system with an Advent low profile unit. We currently do not offer these parts as a package, but you can purchase all of the exact same components separately. To answer your question, yes, the…

view full answer...

Answer 11

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 12

I recommend the Redarc Tow-Pro Liberty Brake Controller #RED24FR for your 2023 Toyota Tacoma with the factory tow package. You will be able to connect the wiring using the Redarc Adapter #RED99FR directly to the factory connector. We also have the…

view full answer...

Installing Redarc Tow-Pro Brake Controller on 2008 Ford F150

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching