Can Double Roller Catches with Prongs 37270235 Replace Ones with Different Measurements

Question

Question:

Do you have a replacement where I won’t have to drill new holes?

asked by: Debra M

0

Expert Reply:

It would be pretty hard to find a roller catch set for your cabinets that would not require drilling so the best option we have would be the part # 37270235.

expert reply by: Jameson C

0

Answer 1

The requested measurements for the Double Roller Catches with Prongs for RV Cabinets, #37270235 are 7/8" by 1-11/16".

view full answer...

Answer 2

You can tow a trailer with a weight distribution setup that does not have the spring bars connected. As long as the head of the system is attached to the shank properly (there's no reason it wouldn't be) it would work just as well as a…

view full answer...

Answer 3

The best way to prevent theft of the Rampage Wireless Backup Camera #RA7710 that you referenced is to remove it from the vehicle when not in use. I attached a review video for this camera for you to check out as well.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Can Double Roller Catches with Prongs 37270235 Replace Ones with Different Measurements

Product Page this Question was Asked From

Continue Researching