What Size Mounting Hardware is Required to Install the Trailer D-Ring Tie Down, # RR06

Question

Question:

What size are the mounting bolts?

asked by: Ron

0

Expert Reply:

The Trailer D-Ring Tie Down, # RR06, has mounting holes that are 1/4 inches in diameter. We recommend using backing plate # BP06 when installing this tie down to provide support for the tire down.

expert reply by: Michael H

0

Answer 1

The Brophy Swiveling D-Ring Tie Down Anchor part #RR06 with the Backing Plate for RR06 Recessed Swivel D-Ring Tie Down part #BP06 are a great, easy to install set of tie-downs which can be used for securing a vehicle. The tie-downs themselves have a…

view full answer...

Answer 2

I pulled a trailer D-Ring from our warehouse and took a measurement for you. the depth of the D-Ring housing from the bottom of the flange with the mounting holes is 7/8 inches. The 1/4 inch mounting holes are spaced 3-3/16 inches apart. The mounting…

view full answer...

Answer 3

I went out into our warehouse and measured the Backing Plate #BP06 and found that the outside dimensions are 6-7/16 inches by 6-1/2 inches. The circle in the middle has a 4-5/8 inch diameter and the overall thickness of the metal plate is .11 inches…

view full answer...

Answer 4

Installation hardware is not included with the Swivel D Ring part #RR06 due to the unknown nature of the surface that the end user will attach it to. Depending on the weight of the object that will be held down, and the thickness of the surface it…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

What Size Mounting Hardware is Required to Install the Trailer D-Ring Tie Down, # RR06

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching