What Loop Tape Goes with the Sew-In RV Slide Tape?

Question

Question:

What loop tape goes with The hook type slide? Cant seem to find out anywhere.

asked by: Tina S

0

Expert Reply:

As long as you have the track system for the Sew-In RV Slide Tape - 6' Long - White # 37281365, the slide tape should work.

expert reply by: Bob C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The etrailer Trailer Hitch Receiver #e98837 which fits your 2010 Toyota Sienna uses six M12 - 1.25 x 40 hex bolts to attach the receiver to the frame. This same hitch is confirmed to fit the 2004-2020 model years. It is possible the threaded holes on…

view full answer...

Answer 5

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

view full answer...

Answer 6

The Replacement Thumb Turn Cam Latch Cylinder part #295-000012 has a 3/4" diameter with 1-1/8" long body measured at the threads. This appears to match what you have listed in the photos so it should be a direct fit replacement by just…

view full answer...

Answer 7

The hook bolt on the Pop-Up Camper Latch and Catch - Zinc #37210825 is a size 12 and has 20 threads per inch.

view full answer...

Answer 8

The correct way to measure a lock cylinder for length is by the threads. The correct way to measure for width is by the two flat spots. Therefore, based on the photo you attached, you will need a 7/8" long lock cylinder like the Camco Cam Lock…

view full answer...

Answer 9

The Sew-In RV Curtain Carrier Tabs part #37281285 and Sew-In RV Slide Tape part #37281355 are designed for the pre-installed curtain tracks on trailers. In most cases, customers simply want to make new curtains so all you would need is the tabs but…

view full answer...

Answer 10

The Snap In RV Curtain Carriers #37281455 that you referenced snap onto the Sew-in Snap Tape #37281005.

view full answer...

Answer 11

The replacement lens for the Omega Single RV Dome Light with Switch #328-001-901XPW (and Double Version #328-001-902XPW) is part #328-89-255 on our site. It does have the same dimensions as what you mentioned but I'm not sure if it will be an…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

What Loop Tape Goes with the Sew-In RV Slide Tape?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching