How Long is the Demco DM05593-97?

Question

Question:

Hello, Im wondering what the overall length of the clevis is? From front to back. Thanks

asked by: Scott S

1

Helpful Expert Reply:

I had the Demco 2-Tang Clevis - Adjustable Channel Mount # DM05593-97 measured and from end to end, it will be 9 1/4 inches long.

expert reply by: Lazer S

1

Demco Measurements
(click to enlarge)

Answer 1

I spoke with my contact over at Demco about clevis #DM05593-97. The squares at the back are 1.88 inches square. And the space between the upper and lower tangs is 2 inches. I have included a picture showing these measurements for you.

view full answer...

Answer 2

The tire size you referenced, 235/85R16, has an overall diameter when fully inflated of about 31-1/2-inches. Therefore the cover you referenced, part #052963753479 from Classic Accessories, would be too tight a fit. A better option is the Classic…

view full answer...

Answer 3

For the dimensions you need, the spacing of the opening between the arms of the #DM05593-97 is 2 inches. As far as the width of the holes, Demco unfortunately does not have the exact diameter. However, they did say that the holes were designed to…

view full answer...

Answer 4

The tire size ST205/75-15 like part #TR20515D will fit in place of a 7.00-15 as the widths are very similar but the tire height will be about 2 inches shorter overall.

view full answer...

Answer 5

The Replacement Inner Slide for Demco DA91 Actuators #DM12808-97 you have pictured is only designed to work with the Demco Hydraulic Trailer Brake Actuator #8759121 or DA91 if you go by Demco's part numbers. It has a 3" x 3"…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

How Long is the Demco DM05593-97?

Product Page this Question was Asked From

Continue Researching