Tang Spacing and Square Opening Measurements on Back on Demco Clevis Adapter DM05593-97

Question

Question:

Hello, I am looking for dimensions: 1. What is the size of rear square openings ? 2. What is the gap between front upper and lower plates? Thank you

asked by: Leo

1

Helpful Expert Reply:

I spoke with my contact over at Demco about clevis # DM05593-97. The squares at the back are 1.88 inches square. And the space between the upper and lower tangs is 2 inches. I have included a picture showing these measurements for you.

expert reply by: Michael H

1

click to enlarge

Answer 1

I had the Demco 2-Tang Clevis - Adjustable Channel Mount #DM05593-97 measured and from end to end, it will be 9 1/4 inches long.

view full answer...

Answer 2

The tire size you referenced, 235/85R16, has an overall diameter when fully inflated of about 31-1/2-inches. Therefore the cover you referenced, part #052963753479 from Classic Accessories, would be too tight a fit. A better option is the Classic…

view full answer...

Answer 3

For the dimensions you need, the spacing of the opening between the arms of the #DM05593-97 is 2 inches. As far as the width of the holes, Demco unfortunately does not have the exact diameter. However, they did say that the holes were designed to use…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Tang Spacing and Square Opening Measurements on Back on Demco Clevis Adapter DM05593-97

Product Page this Question was Asked From

Continue Researching