Replacement Motor For Single Electric Coachstep

Question

Question:

Can you tell me what motor I need for a Coachstep part number 725-0021, SN 03562. The part number of note existing motor is long gone. Thanks.

asked by: Bill

0

Expert Reply:

Based on my research, it looks like the part 725-0021 is a single step electric Coachstep, and we do have the correct replacement motor, which is the following part:

- Replacement Motor for Lippert Electric Coachstep # LC301695

I verified with the manufacturer, Lippert, that this is the correct replacement motor for a single electric Coachstep.

expert reply by: Kyle S

0

Answer 1

I reached out to my contact at Jensen and he did say that your AWM975 model stereo has been out of production for a while. To replace the unit he said the best option is with the Jensen RV Stereo #JWM60A, which features the same cutout size and…

view full answer...

Answer 2

Yes, we do have the replacement remote available in a service pack for your Jensen JWM22 stereo. You will want the Replacement Service Pack for Jensen Stereo #JEN83RR which is the correct service pack for your JWM22 stereo.

view full answer...

Answer 3

I believe what you have is the 7" square Equalizer jacks on your 2022 Class C RV(see image). This would then use the SnapPad EQ Compact Jack Pads for Equalizer Leveling Systems #SP24FR4. If this does not match your jack, please send me any…

view full answer...

Answer 4

I sent all of the pictures you sent me to the current manufacturer of the Coach steps (Lippert) and they told me that the correct module you need is the part #LC301702. Your wire colors might not totally match but the purple wire of the new module…

view full answer...

Answer 5

I have included a picture that shows the troubleshooting steps for the Coachstep brand of RV steps. These steps cover a variety of possible issues. To me it sounds like the control module needs to be replaced, #LC301702. But performing the various…

view full answer...

Answer 6

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Replacement Motor For Single Electric Coachstep

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching