Recommended Skid Wheels For A 2020 Winnebago Intent 29L

Question

Question:

We recently purchased a 2020 Winnebago Intent 29L and have now torn the rear corners off the body twice. The lowest portion RV is the generator exhaust at 14 inches from the ground. The hitch cross bar is 16 1/2 inches from the ground. Can you please assist in how to measure for the correct size and type skids wheels.

asked by: Jeff S

0

Expert Reply:

If your hitch cross bar is 2-1/2" x 2-1/2" then I recommend the Ultra-Fab Rotating, Hitch Mounted Skid Wheels for RVs up to 30' Long - 4" Diameter - Qty 2 Item # UF48-979014. It comes with a rotating wheel to allow you to make turns while the wheel is in use. The wheel is 4" in diameter to help give you a little bit more clearance. The 1/4" thick urethane layers of the outer edge of each wheel provide an anti-skid barrier and ensure that the wheel last even longer by avoiding metal degradation.

expert reply by: Kevin C

0

Answer 1

I went out into our warehouse and pulled a set of the Ultra-Fab Rotating, Hitch Mounted Skid Wheels #UF48-979014 and found that the distance from the bottom of the wheel to where the bottom plate will be is 5-3/4 inches. Since the bumper you plan to…

view full answer...

Answer 2

The distance from the top of the mounting plate to the bottom of the wheel on the Ultra-Fab 4 Inch Skid Wheels, #UF48-979011, is 5-3/4 inches and for the 6 Inch wheels, #UF48-979013, 7-3/4 inches. I have attached a photo for you showing these…

view full answer...

Answer 3

The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…

view full answer...

Answer 4

That's a really good question, and the weight ratings for the Equa-Flex Cushioned Equalizers are per axle as opposed to the weight of the trailer; so you will want to choose the kit that meets whatever your axles are rated for: - 3,000 lbs to…

view full answer...

Answer 5

We have just what you need to replace your landing gear motor M9000PK with the #LC196308 and you'd be set! This is a confirmed fit for what you have and is a faster motor too so your jacks will raise and lower quicker.

view full answer...

Answer 6

I certainly do. For this you are going to want to install skid wheels which will take some of the brunt off your trailer. For this I recommend using the Ultra-Fab Steel Jumbo Roller part #UF48-979023. These skid wheels will need to be welded on the…

view full answer...

Answer 7

I spoke with my contact at B&W who said that you will actually use those brackets to install the B&W Turnoverball Underbed Gooseneck Trailer Hitch #BWGNRK1116 on your 2017 Ford F-250 Super Duty FX. The only time that you will run into a…

view full answer...