How is the Spare Accessed when a Draw Tite Hitch # 36511 is installed on 2012 Hyundai Santa Fe

Question

Question:

Once the trailer hitch is installed, how do you access the spare tire?

asked by: Kayla

0

Expert Reply:

The Draw-Tite Trailer Hitch # 36511 that you referenced does not require you to access the spare tire differently than you normally would. If you check out the picture I attached you will see that the hitch does a good job of not interfering.

If anything you might need to angle the spare in and out to get it around the cross tube of the hitch but that should not be too difficult.

I attached an install video for you to check out also.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

I can certainly help you with that. Since the Curt T-Connector Vehicle Wiring Harness, part #C55384 is a 4-way connector the four functions will be Yellow for the left turn and brake, Green is for right turn and brake, Brown is for running lights,…

view full answer...

Answer 4

I am not really sure what you are trying to do but you can install a trailer hitch on the rear of a trailer. There are two different kinds of trailer hitches for trailers, frame mount and bumper mount. The frame mount hitches are much stronger but…

view full answer...

Answer 5

The Draw-Tite #75908 is more hidden with the recessed aspect of the hitch pin hole being 5-1/2 inches from the outermost part of the bumper. The height is 15-1/2 inches from the inside top of the receiver to the ground. The Curt #C13195 is very…

view full answer...

Answer 6

The Dexter Electric Trailer Brake Kit #23-105-106 are a replacement set for the 023-358-00. This kit includes a right and left brake assembly that is manually adjustable. I recommend the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459 as…

view full answer...

Answer 7

On GM vehicles of that vintage, the 12-V pin should be hot regardless of whether the ignition is on or not. If it isn't showing voltage even with the ignition on, you're almost certainly on the right track thinking it's a blown or…

view full answer...

Answer 8

The most definitive way to determine if your 2013 Kia Sorento has the factory towing prep package is to have the dealer run the VIN number. They will be able to you how it is equipped. The trailer wiring for vehicles with the tow prep package,…

view full answer...

Answer 9

For your 2013 Kia Sorento, the towing capacity is 3500 lb for the V6 models. I recommend the Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2" #75684 for your trailer hitch receiver. This will give you a 2 inch receiver…

view full answer...

How is the Spare Accessed when a Draw Tite Hitch # 36511 is installed on 2012 Hyundai Santa Fe

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching