Replacement Circuit Board for MaxxAir MaxxFan 4401K

Question

Question:

Need a circuit board for a model 4401K serial no 2010-4401k-2105 something went wrong during install

asked by: Leon M

1

Helpful Expert Reply:

The Replacement Printed Circuit Board and Switch for MaxxFan Roof Vents # MA10-04301k-v16 is the correct replacement circuit board for a MaxxAir 4401K MaxxFan.

expert reply by: Erik B

1

Answer 1

You will need a different fan like the MaxxFan Plus Roof Vent #MA00-04500K to have a remote controlled fan. The MaxxAir MaxxFan Mini Roof Vent #MA00-04401M is not capable of being used with a remote. The circuit board does not allow for this type…

view full answer...

Answer 2

For your MaxxFan that is a 4301 Series the correct circuit board is the part #MA10-04301K-V16.

view full answer...

Answer 3

The correct replacement circuit board for your MaxxFan 4401K roof vent is the Replacement Printed Circuit Board and Switch for MaxxFan Roof Vents #MA10-04301k-v16.

view full answer...

Answer 4

Yes. The Replacement Printed Circuit Board and Switch for MaxxFan Roof Vents #MA10-04301k-v16 is the printed circuit board you need.

view full answer...

Answer 5

The part shown in the photo you kindly provided is the manual lift operator. We offer a replacement as part #MA10-20281K-3CF which is compatible with the #MA00-04401M MaxxAir MaxxFan Mini you have.

view full answer...

Answer 6

Yes you are correct the Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX is the right replacement and measures 18 1/8" long and 16 1/2" wide, which is the same measurements as your current MaxxFan Plus Roof…

view full answer...

Answer 7

The replacement circuit board for your MaxxFan 4201 Series is the Replacement Printed Circuit Board and Switch for MaxxFan 4301 Series Roof Vents #MA10-04301K-V16. The 4201 series circuit boards may look different compared to the upgraded circuit…

view full answer...

Answer 8

Thanks for the picture! Based on it I can tell that the correct circuit board is the part #MA10-04301k-v16 that you referenced! The series of fan you have is the 6401k.

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement Circuit Board for MaxxAir MaxxFan 4401K

Product Page this Question was Asked From

Continue Researching