Window Material Of The Lippert Thin Shade Window Kit

Question

Question:

Is the darkened panel made of glass or is it a Plexi of some sort?

asked by: Dave

0

Expert Reply:

The darkened panel on the Lippert Thin Shade Complete Window Kit Item # LC806621 is made of glass and not a plexiglass or other kind of plastic.

expert reply by: Kevin C

0

Answer 1

The SolidStep Manual Fold-Down Steps for 26" to 29-7/8" RV Door Frames - Quad - Aluminum #LC791574 will work fine with most screen door bars like the Camco Deluxe RV Screen Door Cross Bar - 21-1/4" long to 28-5/8" long - Aluminum…

view full answer...

Answer 2

Your concern about being potentially trapped inside your RV is certainly a valid one, and also a common one with the Stromberg Carlson Lend-a-Hand. While there isn't a way to easily stop it from pivoting across the front of the door, there truly…

view full answer...

Answer 3

On the install bracket the install holes measured from center to center from top to bottom is 1 inch. From left to right on center is 1-1/2 inches. The distance from the center of the top bracket to the bottom bracket is 23-1/2 inches. The install…

view full answer...

Answer 4

I confirmed with my contact at StrombergCarlson that their Lend-a-Hand Folding RV Handrail, part #AC-300, and the similar aluminum version, part #AM-200, can both fold either to the left or to the right. These two products differ in that the AC-300…

view full answer...

Answer 5

For enclosed trailer ramp/doors the best option is the style of spring that mounts to the top of the rear door frame and pulls the ramp up like the Enclosed Trailer Ramp Spring #362SA6. The Gorilla Lift you mentioned only works on utility trailer…

view full answer...

Answer 6

The Conventional Ramp Door Spring for 6' Wide Enclosed Trailer part #362SA6 is designed for 38" to 69" wide trailer doors so this is what you'll want to use. The bar will actually be trimmed to fit your exact width.

view full answer...

Answer 7

Trailer ramp door springs are generally chosen based on the inside width of the trailer where it will be installed. Also, ramp door springs such as #362SA6 can be trimmed down some if the length is too much for the trailer. This is the shortest…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...