Which B and W Turnoverball Rail Kit Fits 2004 GMC Sierra 2500 LD

Question

Question:

Will this fit a 2004 gmc 2500

asked by: Robert

0

Expert Reply:

Since the B and W Turnoverball gooseneck hitch that fits your 2004 GMC Sierra 2500 LD is the # BWGNRK1059 the correct rail kit would be the part # BWGNRM1059.

expert reply by: Jameson C

0

Answer 1

The body lift definitely complicated getting a gooseneck hitch installed as the rails for the B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit #BWGNRK1059 will attach directly to the frame of your truck. As i am sure…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 4

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the "new…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

view full answer...

Answer 7

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…

view full answer...

Answer 8

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Which B and W Turnoverball Rail Kit Fits 2004 GMC Sierra 2500 LD

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching